How much does it cost to replace engine coolant temperature sensor?


Sharing is Caring


On average, the cost of a coolant temperature sensor ranges from $20-$80, while the cost of labor ranges from $50-$250. In total, one could expect to pay $70-$330 to have their engine coolant temperature sensor replaced.

How much is a BMW coolant sensor?

The average cost for a BMW 328i engine coolant temperature sensor replacement is between $273 and $330. Labor costs are estimated between $118 and $148 while parts are priced between $155 and $182.

What are the signs of a failing coolant temperature sensor?

  • Poor Fuel Economy.
  • Irregular Temperature Readings.
  • Black Smoke from Your Exhaust.
  • Your Engine is Overheating.
  • Your Check Engine Light is On.

What is normal coolant temperature for a BMW?

Normal Temperature engine temperature gauge Most experts agree that your engine should run between 195 degrees and 220 degrees.

What happens when a BMW overheats?

Excess engine heat can cause radiator hoses and seals to weaken and break, releasing coolant and antifreeze. Driving with an overheated engine can also cause warped cylinder heads, which can lead to a blown head gasket, one of the most expensive repair jobs for BMWs.

How do you check engine heat on a BMW?

YouTube video

Can I drive without coolant temperature sensor?

It is very dangerous to drive a car with no coolant. Driving your car without coolant can cause engine overheating and an overheated engine can trigger significant damage to core engine parts. When the car runs, the coolant must flow around the engine block in order to keep the engine temperature under check.

Can you clean a coolant temperature sensor?

In most cases, there is little to clean and reuse as when a sensor goes out of calibration from wear or mechanical damage, or fails due to heat damage, the only repair is to replace them.

How long does a coolant sensor last?

Often, the engine coolant temperature sensor must be replaced at about 100,000 miles. If you don’t properly maintain the engine cooling system, the sensor could fail much earlier.

What are 10 common causes of overheating?

  • Too little or no coolant. Driving without proper levels of coolant/antifreeze may cause a coolant system failure.
  • Cooling system leaks.
  • A broken water pump.
  • Radiator issues.
  • Oil too low.
  • Thermostat failure.
  • Issues with the belts and hoses.
  • Heater core is plugged up.

Why is my engine hot but not overheating?

There are a few reasons why your car may be hot but not overheating. Most of these reasons are related to your cooling system. It may be that your radiator is clogged or damaged, that your coolant is low, that your water pump is damaged, that your thermostat is damaged, or that your engine is simply overworked.

What temperature does a BMW thermostat open?

Once the temperature of the coolant rises to between 180 and 195 F (82 – 91 C), the thermostat starts to open, allowing fluid to flow through the radiator. By the time the coolant reaches 200 to 218 F (93 – 103 C), the thermostat is open all the way.

How long does it take to replace a coolant temperature sensor?

If you are doing it yourself it will take 4 to 5 hours. However if a skilled mechanic is doing it, it will take 2 to 3 hours only. Whether your car was running or not. If the engine of your car is running, then you will have to wait at least 1 hour before you start replacing the bad coolant temp sensor.

Does coolant temp sensor affect AC?

Inconsistent cooling If the ambient temperature sensor fails or is sending out an inconsistent signal, then the AC system may have trouble maintaining cool and comfortable cabin temperatures.

How do you test a coolant temperature sensor?

Gently lower the end of the sensor into the water until the entire device is fully submerged. Wait a minute or so for the screen to give you a reading of the cold water. Once you have a reading, write down the measurement for reference. A common reading for a temperature sensor in cold water is around 5 volts.

How do I know if my BMW thermostat is bad?

  1. High temperature readings. The main symptoms of a failing thermostat are related to engine overheating.
  2. Erratic changes in temperature.
  3. Leaking coolant.
  4. Increased fuel consumption.
  5. Unusual noises.

How do I fix my BMW overheating?

Here’s what to do if your BMW overheats: Pull over and stop: Pull over at a safe location and shut off the car. Turn on the heat: Turning off the AC and put the heat on high if the vehicle is still moving to safety. Open all windows: This will allow the heat to escape.

How do I know if my BMW water pump is bad?

  1. Coolant Leaks.
  2. High-pitched Whining Sounds.
  3. Engine Overheating.
  4. Steam Coming From The Radiator.
  5. Higher Mileage.
  6. Routine Maintenance.
  7. Regular Coolant Changes.
  8. Any Change In Your BMW’s Performance.

How do you reset the coolant light on a BMW?

YouTube video

How do you diagnose an overheated engine?

  1. Steam (often looking like smoke) coming from the front of the vehicle under the hood.
  2. The engine temperature gauge in the dashboard or driver console spiking to “H” or moving into the red area of the gauge.

Why is my BMW coolant low?

Reasons Why Your Coolant Might Be Low leak in radiator. leak in radiator hoses. leak in water pump. damaged or broken radiator seal.

What problems can a bad coolant temperature sensor cause?

A faulty sensor can cause the fuel mixture to adjust. This causes the engine to shake or vibrate when the vehicle is at low speed and can even bring about strange behaviors, power losses, etc. Engines are highly sensitive, especially to inappropriate air-fuel mixtures at idle.

Can I use water instead of coolant?

Technically speaking yes you can use plain water in your cooling system but it isn’t recommended as a long term solution and certainly not in extreme weather conditions. The problem with using water in your cooling system is that water freezes at 0ยฐC.

Will a car start without a temp sensor?

The sensor will not cause a no start. It could cause a hard start and a rich or lean condition only.

Is there a fuse for coolant temperature sensor?

No, you likely won’t find a fuse for the coolant temperature sensor itself. You can find a fuse for the engine control module though, which sends the signal to the coolant temperature sensor.

Craving More Content?

Carolina's BMW