What happens if BMW key runs out of battery?


Sharing is Caring


If your BMW key fob’s battery has run out, you won’t be able to unlock your vehicle remotely or, if your BMW has Comfort Access, use keyless entry. However, you can still access and start your car manually.

What battery does the BMW key fob take?

For drivers with BMW Comfort Access, BMW key fob battery replacement will require a CR2032 battery. Here’s how to replace the battery from your BMW key fob: Press in the small tab on the side of your key fob, and remove the metal valet key.

Can you replace BMW key battery yourself?

Comfort Access BMW Key Battery Replacement After the valet key is removed, you will notice a small access port on the key fob. Use the valet key or a flat screwdriver to remove the key battery cover. Once removed, you will see the battery. Remove the dead battery and replace it with a new one.

Do BMW key fob need reprogram after changing the battery?

Typically, you do not need to reprogram the key fob after changing the battery. However, if you’ve replaced not just the batteries but also some of the internal wiring and electronics, you may need to reprogram it by pairing it with your vehicle once again.

Can I use a CR2032 instead of a CR2025 in a key fob?

For as long as either fits in the battery compartment, the CR2025 and CR2032 may be used interchangeably with minimal effect although the CR2032 would probably last slightly longer simply because it has a higher capacity (mAh).

Does it matter what battery I put in my key fob?

Most car keys take CR2032 and CR2025 3-Volt batteries, but that doesn’t mean they fit every key fob. Different cars take different batteries. You can find the exact type in the owner’s manual. If the owner’s manual is not handy, you can always check your current key fob.

How much does it cost to replace BMW key fob battery?

If you have a smart key or comfort access BMW key fob, you’ll need to replace the battery by following these quick steps: Purchase a CR2032 battery from an auto shop or department store. You can expect to pay about $2 for it.

How do I reprogram my key fob after replacing the battery?

YouTube video

How long should a BMW key battery last?

BMW key fob batteries need replacement every 3-5 years depending on usage.

Can I replace key fob battery myself?

Key Fob Battery Replacement Automakers make it reasonably easy to swap in a new battery, though you may need to use a small screwdriver to pry the key fob open. Generally, these batteries cost $10 or less, though some fobs require two batteries.

Why is my BMW key not working after battery change?

The most likely reason for a key fob not working is a dead battery. That being said, there are more severe problems your keyfob may be experiencing. If you have a key fob not working after a battery change, you may need key fob replacement or even some form of car door lock repair.

What happens if you don’t reset BMW battery?

If you don’t register it with the car, it causes the car to charge it too much or too little. Older batteries get more charge sent to it than newer ones, so putting a new battery in will cause the car to overcharge it, which prematurely kills your battery.

Can a dead key fob stop your car from starting?

Once you’re inside, getting the car started is actually pretty easy. Automakers know that your keyless ignition may need to work if the fob dies, and the system has been designed to work even with a non-functioning remote.

Can I drive with low battery key fob?

Q: Can I drive with keyless remote battery low? When your car’s keyless remote battery is low, you will still be able to drive around, shift gears, and even park. The key is not required for the car to properly run once you start the engine. You can drive for a long time without the key fob or remote.

How do you start a BMW with a dead battery key fob?

YouTube video

Can I use a CR2016 in place of a CR2025?

CR2016 battery is interchangeable and can replace a CR2025 battery as long as it fits in your device. Otherwise, both of them are 20 mm thick and have the same voltage.

Are CR2025 and 2025 batteries the same?

The Major Differences of DL2025 And CR2025 Almost all battery manufacturers use it. The DL designation, on the other hand, is used by the battery manufacturer Duracell. The CR2025 has the same diameter and thickness as the DL2025, but the DL2025 has a capacity of 150 mAh while the CR2025 has a capacity of 160 mAh.

Can I use a CR2032 in place of a CR2016?

Yes! One CR2032 will replace (2) CR2016’s.

Does a BMW battery need to be programmed?

Does a BMW battery need to be programmed? All BMW models manufactured after 2002 require battery registration, as they are significantly more advanced in terms of electrical environment, which aims to improve the gas mileage.

How often should you change the battery in your key fob?

Key fob batteries should be replaced every three or four years, although this will vary based on their amount of use and build quality. If your key fob were to suddenly stop working when you’re far from home, you’d wish you had cared for it.

Does AutoZone replace key fobs?

But do they make or copy keys? AutoZone does provide key copying services for automotive vehicles such as Toyota, Ford, Honda, Dodge, GMC, Mercedes, Kia, and others. These services include automotive key blanks, key duplication, transponder keys, and key fobs.

Why are BMW key fobs so expensive?

And, in cases of vehicles like Mercedes and BMW, special machinery is required that is exclusive to these brands. So, the cost to cut those keys will be even higher, as only owners of these cars will be charged for the special equipment required to cut those keys.

Is BMW key fob battery covered under warranty?

Does BMW replace these under the 4 year/ 50,000 miles warranty or service plan or will they charge me in which case I can DIY? Yes! They are covered by BMW. The keyfob (I assume you have Comfort Access) is simple.

How do I resync my BMW key fob?

Press the BMW logo on your BMW key fob 3 times while holding down the unlock button. Let go of the unlock button after the third time you’ve pressed the BMW logo. Then, turn on the ignition, and your new key should be paired with your BMW!

How do you reprogram a key fob with a push-button start?

  1. With the fob in your hand, get into the driver’s seat, closing the door behind you.
  2. When you’re ready, press your car’s start button 15 times in quick succession, with no more than two seconds between each attempt.
  3. After the 15th button press, push the lock button on your fob.

Craving More Content?

Carolina's BMW