Place a carpenter’s level between the two marked center lines to see if they are even. If they are not even, use a tape measure to measure how far up the wall the lower mark is and lower the other center line marker to the same height. These center lines should be no higher than 3.5 feet (1.1 m) from the ground.
Table of Contents
How do you adjust the headlight height on a BMW?

Where are headlight adjustment screws?
Open the bonnet and look at the back of the headlight casing, on most models there will be two adjustment screws/bolts on the rear or top of each headlight-locate them and grab the right tool in order to turn them (check the owner’s manual to be sure they’re the right ones).
How do you reset the headlights on a BMW?

How do you manually adjust headlight beams?

What are adaptive headlights on a BMW?
The headlights on a BMW are often called adaptive headlights. This is because they can move the projection of light to the right or left based on how you drive. This provides more clarity to the driver when they turn or go around corners.
What is adaptive headlight malfunction BMW?
The main cause for the failure of the adaptive headlight module is water. This can happen for many reasons, such as driving through heavy rain or flooding, or going through a car wash. When this happens, the adaptive malfunction error message will display on the dashboard of your BMW.
How far should your headlights shine while on low beam?
Your headlights only let you see about 350 feet ahead. Be sure you are driving slow enough to stop or turn if needed. Use your low beams when you come within 500 feet (about one block) of an oncoming vehicle. Also use your low beams when following another vehicle within 300 feet.
What is the correct height adjustment for headlights?
Find the headlight cutoff lines: On the driver’s side of the wall, measure four inches below the axis height you marked and draw another line. On the passenger’s side, draw a line two inches below the axis height. These marks will serve as cutoff points when you adjust your lights.
How do I know if my BMW has adaptive headlights?
The non-adaptive have the LEDs mounted on a plate at the top end of the headlight. The adaptive have them in the middle (horizontally) of the headlight.
How much does it cost to fix BMW Adaptive headlight malfunction?
The average cost for a Headlamp Control Module Replacement is between $841 and $890 but can vary from car to car.
How do you adjust the headlights on a BMW e92?

How far should your headlights shine while on high beam?
High-beam headlights shine at an angle to illuminate the road 350 to 400 feet ahead or about twice as far as low beams.
Why is one of my headlights brighter than the other?
One of your bulbs is aimed higher than the other. This makes it look like one is brighter than the other. You can probably fix it yourself, but the dealer can quickly align them for you too. One of your bulbs is aimed higher than the other.
How much does it cost to get headlights aligned?
The Best in Auto Repair The average cost for headlamp alignment adjust is between $40 and $51. Labor costs are estimated between $40 and $51. This range does not include taxes and fees, and does not factor in your specific vehicle or unique location. Related repairs may also be needed.
How do I know if my BMW has high beam assist?

How do I turn on BMW Adaptive headlights?

Do all BMW have adaptive headlights?
Fully adaptive LED headlights come standard on the following BMW models: G05 X5. G06 X6. G07 X7.
What is adaptive light control?
Unlike traditional headlights, which are in a fixed position and only capable of illuminating directly in front of you, adaptive headlights are not in a fixed position at all times. These headlights use electronic sensors that can detect your steering angle to swivel based on the direction your car is heading.
What are adaptive lights?
Adaptive driving beam (ADB) headlights, also known as smart headlights, can shine more light onto the road ahead without blinding the drivers of oncoming cars.
Are BMW laser lights adaptive?
They’re a fancy version of the adaptive headlights, which provide great illumination and arguably better visibility (half a mile apparently) while using 30% less energy than LEDs.
Will headlights that are aimed too high cause problems?
If your headlights are pointed at the ground it causes glare on the road which negatively affects your ability to see far down the road. If your headlights are aimed a little too high they could be shining into space reflecting off nothing rendering them practically useless!
How do you avoid the glare from oncoming headlights?
When oncoming vehicles shine light directly into your eyes, turn your gaze to the white line on the right side of the road, or to where the pavement meets the shoulder, until the vehicle goes by. All cars have day/night interior mirrors to reduce glare from cars directly behind you.
Why should a driver slow down when driving at night with their low-beam headlights on?
If you must drive, then slow down and turn on your low-beam headlights because the light from high beams will reflect back and cause glare. Never drive with just your parking or fog lights. Increase your following distance and be prepared to stop within the space you can see in front of your vehicle.
How can I align my headlights at home?
Turn the screws clockwise to adjust the headlight inwards and counterclockwise to adjust them outwards. The headlight beam should fall just to the right of the center tapeline. Next, block out the adjusted headlight and do the same vertical and horizontal adjustment on the other headlight. Fine-tune the adjustments.