Where is location for drain plug?

Spread the love

An oil drain plug is a large nut usually located in the lowest point of the oil pan at the bottom of the engine, where all engine oil capacity rests. The reason why it is located here is for it to drain the maximum amount of oil when changing engine oil.

What size is BMW drain plug?

It’s a steel drain plug in the standard M12x1. 5x16mm size.

Where is the drain plug on a BMW 328i?

How many quarts of oil does a 2011 BMW 328i take?

Capacity: 6.9 quarts. . (with filter). After refill check oil level.

What size is BMW e90 oil drain plug?

Figure 4 Using a 17mm socket, remove oil drain plug. Allow engine oil to drain until it stops dripping.

What size socket do I need for oil plug?

Next, locate the drain plug under the car; it should still be warm from the heated engine. Place a 3/8-inch (0.9 centimeters) socket in the socket wrench, fit it over the drain plug’s nut and turn it counterclockwise. The oil drain plug should open easily, draining the used oil from the engine.

What size is the drain plug on a 2013 BMW 328i?

Dorman – Help – Standard Engine Oil Drain Plug: M12-1.50 Thread, 15 mm Head, 1 Pack (Part No. 69014)

Where is my drain plug located?

The drain plug is a large nut or plug located under the oil pan at the bottom of the engine. If you can’t reach your oil drain plug easily, you’ll have to either crawl under your car to reach it or jack up the car.

Where is the engine oil drain plug located?

Look under the car and locate the drain plug: It is a large nut or plug located under the oil pan (large tank) at the bottom of the engine.

Should I use 5w30 or 5w40?

5w30 can be used by different type of vehicles and in different range of temperatures, but is ideal for colder temperatures. 5w40 is often used in higher mileage engine sand performs better in warmer temperatures.

Can you put 5w30 in a BMW 328i?

A BMW 328i takes a synthetic, high-performance SAE 5W-30 engine oil. Recommended brands include: Mobil Full Synthetic 5W-30 High Mileage, 5W-30 Pento High Performance.

How often does a BMW 328i need an oil change?

BMW recommends getting your BMW 328i oil & filter changed every 12 months or 10,000-12,000 miles, but it’s first-rate to check your owner’s manual and with your dealer to find out the intervals that work first-rate for your vehicle.

Is 5w 40 oil OK for BMW?

Fully Synthetic 5w40 Engine Oil This oil can be used within many Volkswagen, Audi, Seat, BMW, Skoda & Renault engines, if you are unsure if this product is for your car then please get in touch with your registration and we will be happy to help.

What size is the oil drain plug for a 2008 BMW 328i?

Dorman – Help – Standard Engine Oil Drain Plug: M12-1.50 Thread, 15 mm Head, 1 Pack (Part No. 69014)

What tools do you need for a BMW oil change?

  • Engine Oil: A good capacity will be approximately seven quarts.
  • BMW Oil Filter Tool: A good dimension is 86mm.
  • BMW Oil Filter: Replacement filters should be tailored for a minimum of 7500-mile oil change intervals.
  • Ratchet Wrench.
  • Jack Stands.
  • Car Jacks.
  • Wheel Chocks.
  • Metric Sockets.

Should oil drain plug be tight?

You never want the drain plug too loose as losing the drain plug and leaving your oil along the interstate isn’t fun. The best advice on the drain plug is to tighten it finger tight where the gasket touches the drain pan surface, then roughly a quarter turn on the drain plug.

What size screw is oil drain plug?

Engine Oil Drain Plug | 090-164 | Oil Drain Plug Standard M14-1.50, Head Size 13Mm | Dorman Products.

Are all drain plugs the same size?

There is no universal drain plug size, but there are only a couple different sizes in common use. Auto shops do not need to replace the plug, it is almost always reuseable. The disposable part is just a sealing washer or gasket. Most shops probably reuse that instead of replace it.

How many quarts does a BMW 328i hold?

5.3 quarts (with filter).

What size is BMW oil filter wrench?

This 86.6mm 16 flute oil filter wrench is compatible with BMW and Volvo engines that have a smooth top oil filter cap.

How much oil does a BMW 328i take?

Capacity: 5.3 quarts. . (with filter). After refill check oil level.

Can you change oil without removing drain plug?

Can you drain oil without removing a drain plug? – Quora. Unfortunately yes. A straw like tube goes down the oil dipstick tube and sucks it out with a vacuum type machine.. Best is to the get oil hot and pull the plug, Bottom of the pan gunk is drained out.

What does an oil drain plug look like?

Should I replace oil drain plug?

You definitely do NOT need anew drain plug at every oil change. Depending on the vehicle , you MAY need a new crush washer at every change ( gasket). If you have been told that you need to replace both at every change by a dealer, quick change place or other, you have been being ripped off.

Why can’t I get my oil plug off?

You need to let your car warm-up After a few minutes, climb under your car and locate the drain plug and turn it counterclockwise. With the engine still warm you should have an easier time of being able to remove the plug from the oil pan.

Do NOT follow this link or you will be banned from the site!